Tools

This little thing is for tracing lines from  inside a panel such as finding the path of the an inner bulkhead so you can drill hopes for fastners.

These are clamp down tools for holding things down. For example you could use these on a radial arm saw to clamp the material down so it couldn't move.

This tool is what you would use to drill prefectly centered holes in tubing.

This is a guizmo made to pull in the spring half of a Dzus fastner Button that won't quite reach or is to hard to rotate into our out of the lock position.

This is a Dremel tool which is invaluable in a project like this.

It's used for everything from triming parts to actually cutting holes in them like a router. It also is used for a drill for small bits.  The one in the photo above also has a 90 degree adapter for getting into confined areas

This is a tool for setting the pitch on the tail rotor blades and what ever else you want to check the angle on.

I'm not positive but I think you can obtain one of these from a hobby shop.

End