Interior panels

These were not anywhere near as easy to cut as they appeared to be.

The sides are relatively easy to cut and install as long as you don't get in a hurry and just trim a little off at a time. 

The roof panels are a bit of a chore to get right. If you line up the liners to the eyebrow windows the pilots side in particular is too long and the curl on the front edge is too far out and doesn't match up with the passengers side.  You'd think you could just twist them one way or another but you can't because you must hold them in place at the eyebrow windows or they won't look good there. There wasn't alot of time spent by RotorWay matching the liners to the eyebrow windows because they are close but they don't completely cover the window flange.

There's a new set RotorWay sells now.

I saw a set of them on a ship at Homer's this year and they look good and I'm told they install easy and there much better fitting but I think they are about $200.00 dollars. Our ship was built with the older style that go between the seatback and the body so we're afraid using them now would cause trouble with all our screw holes lining up.